1. Poultry Feed Pellet Mill Feeder
The feeder consists of speed-adjusting motor, reducer, screw
hopper, and screw oar.
2. Animal Feed Pellets Process Machine Conditioner
The conditioner is mainly made up of carbon steel or full stainless
steel, mix oar, temperature display, motor and steam adding hole.
Its function is passing 0.10.4Mpa dry steam to make steam and
feedstuff mix enough, to make material soft and pasted then goes
into the pressing store.
The mixer hopper, mixer axis and oar are all made of carbon steel
or stainless steel, so it is propitious to working in
high-temperature and high-humidity environment.
3. Animal Feed Pellets Process Machine The pressing store
Through the cover of ring die and feeder scraper, the powder
material accumulate in the two pressing districts, belt wheel
drives the ring-die rotate, the material is rolled between the
ring-die and the pressed roller, two opposite
rotating parts press the material gradually into the hole of ring
die, shaped in the hole and extrude out of the hole, knives by the
column strip in the length you need, finally the shaped pellets
roll out of the machine.
The axis of pressed roller is eccentricity running it will change
the gap between die and roller, the gap-adjusting completes through
running the wheel.
4. The security system The security system is made up of overload
protection, the pressing store door and cover, anti-operation trip
switch and outflow from the machine.
a. Grains Feed Pellet Making Machine Overload protection
When hard impurity into pressing district or flow of material is
too big, pressure between ring-die and pressed roller is over
normal,
Spindle bear torque above normal and Shear stress which Pass safety
pin is also above ultimate strength, then safety pin broken, making
spindle spline block rotate and touch trip switch to stop.
b. Corn Feed Pellet Press MachineMachine Mill Door and cover
protection switch During working, to avoid unnecessary casualties
because of high speed rotating when open the door and cover of the
pressing store, then install a security trip switch on the left
side of the door and cover. When open the door and cover, the trip
switch break control circuit of the pellet mill to make the pellet
mill stop or can not start up to keep people safe.
1) High precision gear driving is adopted, resulting in high
driving efficiency and stable working.
2) The feed pellet machine is fitted with deranging and overload
protection device and protection on the machine is fully considered
during the operation.
3) It can be fitted with single-layer, multiple-layer jacket
conditioners or double-shaft differential conditioner so as to meet
the different requirements of producing high grade livestock and
poultry feed and aqua feed.
